Archive for September 25th, 2011
When you run the Windows checkdisk (chkdsk) utility, it may report the disk being in use and recommend that you schedule chkdsk to run the next time the computer restarts, like the following screenshot shows:
Windows can’t check the disk while it’s in use. Do you want to check for hard disk errors the next time you start your computer?
However, doing that ran me into a very curious issue on Michele’s laptop: I would restart the computer, and get a message telling me to press any key within a few seconds to abort the scan if I so desired. Sorry, but I don’t have the exact message in front of me at the moment. Curiously it would abort itself after a second or two, stating that I pressed a key (which I did not). I’m fairly certain this is caused by this issue here: kernel atkbd.c: Unknown key released messages on Linux.
In order to make the chkdsk run without aborting due to that phantom keystroke, you have to set the delay to zero. To do this, boot back up into Windows, open an administrative-level command prompt, and run the following:
That will set the delay to zero seconds, effectively making it unable to be interrupted. Schedule the disk check again and reboot. It should run without issue.
Questions, comment, or any issues with the above are welcome in the comments section. Thank you!